EasyWeather data file format. I sawed a single slit, about an inch long, in the end of the tube. Only you know what your requirements are, so it’s up to you to decide what’s best for you. This required fitting a longer cable and I managed to route the cable inside the extension. Even after doing this I don’t hold out much hope of truly accurate readings. How do I change the library path as mentioned by Jordan and Jay R Also how to change the path to libusb. I also rewired the wind vane and routed its cable inside the mast.
|Date Added:||2 June 2007|
|File Size:||13.25 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Fitting the alternative mast was quite simple.
Twitter is slightly trickier but once done works well also. Please forgive my simple question. I ush a single slit, about an inch long, in the end of the tube. No matter what I do, I get an error when I do the following: No module named Cython. At the top are the wind speed and direction sensors.
Someone has already done that using a radio receiver attached to gpio bypassing the console. You are commenting using your Facebook account.
I then tried a WLgP V2 and found that it works. By continuing to use this website, you agree to their use. The second part is OK though, take a look at 1-wire. To find out more, including how to control cookies, see here: I really need to find the time to do the rebuild. In November I dismantled the rain sensor and found that a spider had moved in and tied up eaysweather mechanism with its eastweather.
Only you know what your requirements are, so it’s up to you to decide what’s best for you.
Installing a USB Weather Station on a Raspberry PI Part 1 – Peter Mount’s Blog
No matter what I do, I get an error when I do the following:. Presence on this list or absence from it does not mean I recommend or not the software.
I used a 32mm to 20mm reducing coupler for MDPE water pipe to join the new mast to the weather station’s stainless steel mast, giving quite a neat result as shown in the third picture. This tutorial is now a few years old, so my only advice is to research how the Cython package has changed over time. I added a balance weight to the front to compensate for the weight of the wedges.
Installing a USB Weather Station on a Raspberry PI Part 1
Yes the graphs are pretty basic. When I type vi setup. Distutils has been renamed or moved. I mounted the N96GY wind sensors on a 32mm diameter aluminium alloy tube sold for mounting TV aerials. With raspian this uzb easy as you get prompted on the first boot to do it. I finally got the TestWeatherStation module to work. Notify me of new comments via email. First we need to install some dependencies: Hello, I installed successfully pywws on my Rasp.
You are commenting using your Twitter account. This is all done with a combination of Python and gnuplot. I purchased a second for spares because the transmitter unit tends to fail. You can read more about his installation on his blog. I have got as far as cython hidapi.
Nice little project i can work on with my son. Take a look at part 3 here: