+123 456 4444

EMULEX ONECONNECT 10GB NIC LINUX DRIVER

I am a new user I am a returning user. Red Hat Enterprise Linux Server release 6. I am currently trying to use this info for by-passing the errors with the dropped RX packets. The TX buffer is always 0. Could post output from “lspci -v”? Also, we cannot use jumbo frames, may be a relation exists?

Uploader: Juzuru
Date Added: 1 November 2013
File Size: 14.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23926
Price: Free* [*Free Regsitration Required]

Registration is quick, simple and nuc free. PawelLasek I will do the necessary installation, including kernel recompilation if necessary as well documentation of operations performed. In the latest post, it happened on two BLc G7 servers – can you give more information – was it high error counts?

CZJC9Y Basically, when looking at various parameters of the card, we found that a ethtool -S eth0 is giving a wide range of errors: If it is not in the man pages or the how-to’s this is the place!

And there was a suggestion to turn off TSO just to see if that made a difference and it didn’t.

Are you new to LinuxQuestions. This book contains many real life examples derived from the author’s experience as a Linux system and network administrator, trainer and consultant.

  BEURER BC58 DRIVER DOWNLOAD

CONFIG_BE2NET: ServerEngines’ 10Gbps NIC – BladeEngine 2

Having a problem logging in? If the result is the same, I’d start suspecting hardware. The time now is The reason that I can think of is incorrect drivers.

You are currently viewing LQ as a guest. Welcome to the most active Linux Forum on the web. If you’d like to contribute content, let us know. We need a Linux-head to review the current setup and to configure as needed. Given the fact that HP is delivering servers “in the flow” to our company, the chipset aren’t the same from one box to another but the 10 considered servers are the same series and all have the same problem.

– Problem with Emulex Corporation OneConnect 10Gb NIC (be3) be2net driver

Did a cable replacement between server to swicth and replace SFP in both side, no luck as of now. I am a new user I am a returning user.

I am a professional system administrator and my experience is more than 9 years of practice. Just starting out and have a question? Open Source Consulting Domain Registration. Based on the firmware version, 2. Please check your private box for more informations. The TX buffer is always 0. Enter your password below to link accounts: Kernel loads the driver and then driver searches for the corresponding device, if driver is unable to find the device for which it is build it fails and the device is failed to load.

  GILSSON USB SERIAL ADAPTER DRIVER

I will do the necessary installation, including kernel recompilation if necessary as well documentation of operations performed.

Install & configure Linux server for Emulex 10gb NIC

Unfortunately, we have failed to install the drivers correctly and so the NIC 10tb not performing as expected. Also, I’m not sure, but it linuz like very old firmware – where do you look for up-to-date firmware? Is there any way that we can initialize these NIC cards and make them available in ifcfg -a so that, I can edit the mac ids of these NICs and configre ifcfg-eth2 and ifcfg-eth3.

Thank you very much in advance Red Hat Enterprise Linux Server release 6.

I suspect the be2net driver to be the problem. Visit the following links: All forum topics Previous Topic Next Topic.