+123 456 4444

INFOCUS LP340B DRIVER

Audio Problems Audio Problems No audio or sound is scratchy or distorted. Both are also available separately. Navigate to the Display menu. Remove the two Phillips screws on either side of the CableWizard connector. Flash or reflash the projector with the latest software.

Uploader: Kazragor
Date Added: 8 May 2009
File Size: 45.47 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67569
Price: Free* [*Free Regsitration Required]

Page 13 Swing the front bezel away from the lens side so that the hinges under the IR lens disengage from the top and bottom cases.

Page 97 badtint Bad or missing tint or color. Voltage and resistance testing is easy too.

Remove the bottom case see page Page 43 Place one finger on the top of the DMD. Improperly handling the DMD outside of the optical engine could result in replacing both parts.

INFOCUS Lp340b – DLP Projector

The projector rests on this foot and the leveling foot in the rear and on the elevator in front. Make sure the DMD fits into the opening in the proper orientation. You may want to save it in a temporary folder or in the Briefcase. Torque the two captive screws to 6 in. A frame made of metal and plastic holds the reflector assembly ifnocus place inside the projector. Show More Show Less.

  IBUYPOWER BASE SYSTEM DRIVER

Make sure the video player has an S-video Out port and cables.

InFocus LP340B Manuals

Consoles by Rick Broida 8 days ago. A fan is not running, causing infodus unit to Blower Replace overheat and shut down. You can pull everything out of the case by removing just a few screws. Install the four M3x8 screws that fasten the controller ECA to the chassis shown below.

Remove the DMD protective cover. Then swing the bezel into place. Use a known good remote with the projector. The lamp door xx covers the lamp module. Seat the actuator end so that it goes through the elevator housing. Fasten the bezel to the projector with the black M3x8 screw. Xbox, PlayStation, movies, phones and more Heck, I even threw in a desk. This is a thermal issue due to one of the following: Then lower the chassis into the top case, making sure the lamp connector emerges through its hole in the lamp housing.

InFocus LPB – DLP projector Overview – CNET

Resetting the Lamp Timer The lamp timer measures the number of hours a lamp is lit. It contains the circuitry that manages the major functions of the projector, including TV, video and computer signal processing. A tab on elevator housing prevents the shaft from dropping through the housing when it is fully extended. Make sure cables are good.

  DP-8045 WINDOWS 7 DRIVER DOWNLOAD

If the bias setting on the controller ECA correctly corresponds with the setting on the DMD label, you leave the setting as it is. Withdraw the shaft from the outside of the bottom case. Swing the front bezel away from the lens side so that the hinges under the IR lens disengage from the top and bottom cases.

The DMD should fit loosely into the opening, and the pins on opposite corners should fit into matching holes on the engine casting. Remove the thermal switch from the top of the lamp housing. Page 83 Click OK.